A long drive from downtown Houston, in Austin County, a country kitchen in Bellville with a long run of counter can need a seam where one slab ends.
Choosing between the stones
The first choice is natural or engineered. Granite, quartzite and marble are cut from the earth, so every slab is different and you pick the actual slab we cut. Quartz and porcelain are made to a pattern, so a sample shows you what the whole slab looks like. After that, the choice comes down to heat, care and look.
Granite is the working stone. It takes normal pan heat and resists scratches, and it needs a penetrating sealer. Quartzite looks closer to marble and is harder than granite, with the same need for sealer. Quartz asks for no sealer at all and stays clean with soap and water, but it wants a trivet under a hot pot, and it never goes outside, because sunlight yellows its resin.
Marble etches from acids and scratches more easily than the others, and it needs resealing over the years. People who choose it for a kitchen choose the patina too. Porcelain is thin, often 12 mm, and it resists heat, sun and stains. Its printed face can stop at the edge, so a mitered edge is the common fix, and it needs a solid, level base underneath.
Seams and overhangs
A long run or a large island can need more than one piece of stone. Where the layout allows, the seam goes at the sink or the cooktop, where a cutout already breaks the surface. We cut the joint tight in our shop and fill it on site with epoxy tinted to the stone. A seam is visible if you look closely, and a busy pattern hides it better than a quiet one. You see the seam plan at template, before anything is cut. Seating at an island needs knee room, and on 3 cm stone any overhang deeper than 10 inches gets support brackets.
Vanities, fireplaces and backsplash
Stone goes well beyond the kitchen. Vanity tops can run in 2 cm stone, and when the sizes work, a small vanity can come out of the kitchen slab. A fireplace surround can match the kitchen or contrast with it, and marble is a classic there, since a surround sees little wear. Backsplash can stop a few inches above the counter or run full height to the upper cabinets, and a full-height splash cut from the counter slab carries the pattern up the wall. Each of these starts with the same free estimate as a kitchen.
How a job runs
Every job runs through the same steps with the same crew. It starts with a free estimate at the house. We look at the cabinets, the sink and the cooktop, bring samples of all five materials and give you a written price, with tear-out and the sink install as their own lines. Then you choose the stone. Granite, quartzite and marble are picked slab by slab at any stone yard: you send us a photo of the slab tag, and the slab is confirmed at template. Quartz and porcelain are picked from samples.
Once the cabinets are set and level, our templater comes back and records every wall, run and cutout with a digital template. Someone should be home for that visit, since seams and overhangs get settled on the spot. In our shop, we cut the slab to that template, polish the edges and cut the sink and cooktop openings.
On install day, the crew takes out the old tops and hauls them away, sets the new stone, fills the seams with color-matched epoxy, sets the sink and drills the faucet holes. Granite, quartzite and marble get their sealer before the crew leaves.
Planning the template visit
The drive to a house well outside Houston takes time, so it helps to have everything the template depends on ready before that visit: the cabinets set and level and the counters cleared. The install brings the finished tops, the epoxy and the sealer on the same truck.
Where we work and how to start
Close to Bellville, we also work in Sealy, Hempstead and Prairie View.
If you are planning new countertops in Bellville, send the estimate form or give us a call. We bring the samples, and you bring the questions.