In Travis County, a house in Bee Cave may still have its builder's countertop on cabinets that were set for it.
Choosing between the stones
The first choice is natural or engineered. Granite, quartzite and marble are cut from the earth, so every slab is different and you pick the actual slab we cut. Quartz and porcelain are made to a pattern, so a sample shows you what the whole slab looks like. After that, the choice comes down to heat, care and look.
Granite is the working stone. It takes normal pan heat and resists scratches, and it needs a penetrating sealer. Quartzite looks closer to marble and is harder than granite, with the same need for sealer. Quartz asks for no sealer at all and stays clean with soap and water, but it wants a trivet under a hot pot, and it never goes outside, because sunlight yellows its resin.
Marble etches from acids and scratches more easily than the others, and it needs resealing over the years. People who choose it for a kitchen choose the patina too. Porcelain is thin, often 12 mm, and it resists heat, sun and stains. Its printed face can stop at the edge, so a mitered edge is the common fix, and it needs a solid, level base underneath.
Edges and thickness
We cut ten edge profiles in our shop. Eased and beveled edges keep a clean, square line. Half bullnose and full bullnose round the front for a softer feel. Ogee and dupont add a curved, more formal shape. A chiseled edge looks rough on purpose, and a cove edge curves under the top. Mitered and laminated edges add a second strip of stone at the front, so the top reads thicker than the slab. For thickness, 3 cm is the standard for kitchens, and 2 cm is used for vanities or under a laminated edge. On 3 cm stone, an overhang deeper than 10 inches needs support brackets.
Seams and overhangs
A long run or a large island can need more than one piece of stone. Where the layout allows, the seam goes at the sink or the cooktop, where a cutout already breaks the surface. We cut the joint tight in our shop and fill it on site with epoxy tinted to the stone. A seam is visible if you look closely, and a busy pattern hides it better than a quiet one. You see the seam plan at template, before anything is cut. Seating at an island needs knee room, and on 3 cm stone any overhang deeper than 10 inches gets support brackets.
From estimate to install
You will see us three times. The first visit is the free estimate. We measure enough to price the job, check the cabinets for level, look at the sink and the cooktop and bring samples, so you can see each stone in your own light. The written price lists the stone, the edges, the cutouts, tear-out and the sink install line by line.
The second visit is the template. It happens once the cabinets are set and level. Our templater records the room digitally, which catches walls that are out of square, and settles the seam placement and the overhangs with you. Nothing is cut before that. In our shop, the slab is then cut to the template, with the sink and cooktop openings cut and the edges polished.
The third visit is the install. The crew removes the old tops and takes them away, sets the stone on the cabinets, fills the seams with epoxy tinted to the stone and sets the sink. Faucet holes are drilled on site at install, where the faucet will sit. Natural stone gets sealer, and the crew cleans up before it leaves.
The scheduled trip
Every Austin-area visit rides the same scheduled trip from our Houston shop. Samples come to the estimate, and between trips the slab is cut to the template in that shop, so the install trip brings the finished tops, the epoxy and the sealer in one run.
Where we work and how to start
Other places near Bee Cave on our list: Lakeway, Dripping Springs and Austin.
Ready to price new tops for a house in Bee Cave? Send the estimate form or call, and we will set a time to visit with samples.